6
SQ600WC
INSTALLATION
INSTALLATION
Warning! Please check for any hidden pipes and cables before drilling holes
in the wall.
Fixing the riser
Mark a vertical center line from the valve up the wall, slide the riser support onto the riser
from the bottom followed by handset holder, temporally position the riser into the valve.
Mark the position of the riser support on the wall making sure that the riser support is
below the curve of the riser.
Place the bracket on the centre line and mark the position of the two fixing holes.
Drill the 2 x 6mm holes to a depth of 35mm and insert the wall plugs.
Secure the bracket to the wall using the supplied screws, and slide on the cover
(see fig 1).
Secure the shower rose to the riser using the fibre washer (see fig 2).
Remove the riser nut and ‘O’ ring from the valve and slide onto the riser. Push the riser
down into the connection outlet on the valve, slide down the ‘O’ ring and tighten the riser
nut.
Slide the riser support to meet the bracket and screw together.
There are 2 flats on the
bracket pillar to aid tightening.
Insert a fibre washer into the long cone end of the hose and screw to the handset.
Insert the second fibre washer into the short cone end of the hose and attach it to the
mixer outlet.
5
FIG. 1 RISER BRACKET ASSEMBLY
FIG. 2 SHOWER ROSE ASSEMBLY
INSTALLATION
RISER
SCREW
FIBRE WASHER
COVER
WALL PLUGS
RISER
SHOWER ROSE
BRACKET
AND PILLAR
HANDSET HOLDER
RISER
FIBRE
WASHER
OUTLET
SHOWER HOSE
OUTLET
CONNECTION TO
COLUMN
SHOWER
HOSE
FIBRE
WASHER
SHOWER
HOSE
RISER NUT
SUPPORT
CONNECTION TO
HANDSET