GENERAL SAFETY INSTRUCTION
2
-Wear proper gloves and protective clothing to prevent your skin from being
exposed to hot metals, UV and IR rays.
-Do not overuse or overheat your welder. Allow proper cooling time between duty
cycles.
-Keep hands and fingers away from moving parts and stay away from the drive
rolls.
-Do not point MIG gun at any body part of yourself or anyone else.
-Always use this welder in the rated duty cycle to prevent excessive heat and
failure.
1.4 Specific Areas of Danger, Caution or Warning
Electrical Shock
Electric arc welders can produce a shock that can cause injury or
death. Touching electrically live parts can cause fatal shocks and
severe burns. While welding, all metal components connected to
the wire are electrically hot. Poor ground connections are a hazard, so secure the
ground lead before welding.
-Wear dry protective apparel: coat, shirt, gloves and insulated footwear.
-Insulate yourself from the work piece. Avoid contacting the work piece or ground.
- Do not attempt to repair or maintain the welder while the power is on.
-Inspect all cables and cords for any exposed wire and replace immediately if
found.
-Use only recommended replacement cables and cords.
-Always attach ground clamp to the work piece or work table as close to the weld
area as possible.
-Do not touch the welding wire and the ground or grounded work piece at the
same time.
-Do not use a welder to thaw frozen pipes.
Fumes and Gases
-Fumes emitted from the welding process displace clean air and
can result in injury or death.
-Do not breathe in fumes emitted by the welding process. Make
sure your breathing air is clean and safe.
-Work only in a well-ventilated area or use a ventilation device to remove welding
fumes from the environment where you will be working.
-Do not weld on coated materials (galvanized, cadmium plated or containing zinc,
mercury or barium). They will emit harmful fumes that are dangerous to breathe.
If necessary use a ventilator, respirator with air supply or remove the coating
from the material in the weld area.
-The fumes emitted from some metals when heated are extremely toxic. Refer to
the material safety data sheet for the manufacturer’s instructions.
-Do not weld near materials that will emit toxic fumes when heated. Vapors from
cleaners, sprays and degreasers can be highly toxic when heated.
