Crossfire CF140L, Руководство пользователя

Страница: 19 / 59

'X_
BASIC MAINTENANCE PROCEDURES
DRIVE CHAIN Cont.
'
1
Use the diagram below to detennine if the sprockets need to be replaced. Never use a new chain with a
damaged or worn sprocket.
THE USE OF A NEW CHAIN ON A WORN
SPROCKET WILL CAUSE RAPID CHAIN
WEAR.
CHAIN ROLLER
Worn Teeth
REPLACE
Damaged Teeth
REPLACE
GOOD
CHAIN ROLLER INSPECTION
I. Check the lower
O
roller for wear and damage.
2. If the roller is worn or damaged, it must be replaced
before your next ride.
3. If the roller has been worn down, then the roller must
be replaced.
4. If you cannot or do not know how to replace the roller,
take the motorcycle to an Crossfire Motorcycles dealer
for service.
42
A .
NEVER RIDE YOUR MOTORCYCLE IF THE
ROLLERS ARE WORN EXCESSIVELY.
ALWAYS USE HIGH QUALITY LUBRICANT
FOR THE DRIVE CHAIN.
BASIC OPERATION & RIDING
'X_
STARTING & STOPPING THE ENGINE
I
Always follow the proper starting procedure as described below.
STARTING PROCEDURE (ELECTRIC START)
Starting When the Engine Is Cold
1. Turn the key switch to the "ON" position.
2. Make sure the transmission is in the neutral position.
3. Turn the fuel tap to the "ON" position.
4. Lift the choke lever up.
5. Press and hold the brake lever on the right side of the handle bar.
6. Open the throttle no more than 1/4 of the way.
7. Press the start "yellow" button until the engine starts.
8. Release the button as soon as the engine starts.
9. After about 1 minute after the engine starts, push the choke lever down.
I 0. Wait until the engine warms up for approximately 5 minutes. After the 5 minute warm up, you are
ready to go.
Starting When the Engine Is Warm
I. Repeat steps 1, 2, 3, 5, 6, 7, and 8 in section "Starting when the engine is cold".
STARTING PROCEDURE (KICK START)
Starting When the Engine Is Cold
I. Turn the key switch to the "ON" position.
2. Make sure the transmission is in the neutral position.
3. Turn the fuel tap to the "ON" position.
4. Lift the choke lever up.
5. Press and hold the brake lever on the right side of the handle bar.
6. Open the throttle no more than 1/4 of the way.
7. Open the kick start lever and from the top of the kick starter stroke, kick through to the bottom with a
rapid continuous motion.
8. After about 1 minute after the engine starts, push the choke lever down.
9. Wait until the engine warms up for approximately 5 minutes. After the 5 minute warm up, you are
ready to go.
Starting When the Engine Is Warm
I. Repeat steps 1, 2, 3, 5, 6, 7, and 8 in section "Starting when the engine is cold"
19