SAC
BAND
mixbox
CROSSFIRE
Page 3
Connect REM to remote
turn-on lead of source unit.
Page 2
SYSTEM WIRING 1 CH.
MONO MODE CONFIG.
c3-500D
ELECTRICAL CONNECTION
+12V
Connect the +12 volt terminal of the amplifier to the p12 volt terminal of the car
battery.
REM
Terminal to be Connected with Remote cable, which comes from the source and which
controls the amplifier switching on. Applied voltage must be between 10V - 15V DC.
GND
Ground Terminal. Connect to the car chassis. Keep the length of the ground cable to a
minimum.
Connect REM to remote turn-on
lead of source unit.
Connect GND to chassis
ground of vehicle*
Connect +12V to
positive 12V of battery
with the appropriate
FUSE value.
SPECIFICATIONS
The C3-500D is not equipped with an internal fuse in itself. Make sure you install in-line
fuse holder from the Positive ( + ) terminal of battery.
C3-500D minimum working impedance is 1 Ohm.
CAUTION!
Optional: XPR
2~8 Ohm
2~8 Ohm
SAC
BAND
mixbox
CROSSFIRE
RMS Power @ 12.5 VDC
Power @ 4 Ohms
Power @ 2 Ohms
Power @ 1 Ohms
Bridged Power @ 4 Ohms
Min. Speaker Impedance
THD Distortion
Frequency Response
Input Sensitivity
Signal-to-Noise Ratio
4-Way Protection Circuit
Crossover Network
Low Pass Filter
Bass Boost
High Pass Filter
Ruse Rating
Heat Sink Size L X W X H
60W X4
80W X4
N/A
160W X2
2 Ohm Stereo
0.05%
10Hz - 30KHz
0.15V - 6V
>90dB
DC Offset,Thermal,
Low / Over Voltage
50Hz - 500Hz
0dB - 12dB
50Hz - 5KHz
40A X1 (Internal)
11.5” X 6.6” X 2”
180W X1
300W X1
500W X1
N/A
1 Ohm
0.10%
10Hz - 350Hz
0.15V - 6V
>85dB
DC Offset,Thermal,
Low / Over Voltage
40Hz - 180Hz
0dB - 12dB
N/A
40A X1 (External)
8.2” X 6.6” X 2”
C3-500D
C3-604
