Crossfire Bed Shaker 520, Руководство пользователя

Страница: 5 / 11

8
9
Silencing Nuisance Alarms
Crossfire Features and Functions
Testing the Bed Shaker 520
Every Crossfire alarm or product should be tested weekly to ensure proper operation.
To test the Bed Shaker 520 or any Crossfire alarm,
press and release the button on the front face of
the unit.
The unit will beep three times, the FIRE light will
flash, and the shaker will vibrate.
All four icons will strobe to indicate a successful
test.
The Bed Shaker will then send out a network test
command and all other alarms on the network will
perform the same self test.
If the unit fails, the horn will emit a steady honk.
Check the batteries. If the unit still fails, contact the
manufacturer.
The Crossfire family of products is equipped with a silence feature that will
decrease the sensitivity of an alarm and silence nuisance alarms.
If in the course of normal activity, cooking smoke,
steam or other gases cause the alarm to activate,
the alarm can be silenced for ten minutes by
pressing the button on the front face of the
alarm.
If the quantity of smoke is too great, the
alarm will not silence until the air has
cleared sufficiently.
Due to its convenient placement in the home,
the Bed Shaker 520 can be easily used to silence
alarm warnings. Because the Bed Shaker is not an
alarm itself, only remotely activated alarms will
be silenced. The initiating alarm must be silenced
directly.
Creating Your Radio Network
The Crossfire product line communicates on its own private radio network. This
network is created simply by powering up new units one at a time.
General Note:
The radio network is limited to 18
total units. Only 12 of these units may be smoke
alarms, the remaining units can be CO and heat
alarms.
The blue RADIO light will begin to flash slowly.
While the blue RADIO light is flashing, additional
Crossfire alarms and products may be added to
your network.
At any time during this period, the Bed Shaker
520 may be added.
The Bed Shaker has been added
to your network!
Activate your first alarm by moving the slide
switch located on the back side of the alarm in
the direction indicated by the arrow.
One minute after activating the last alarm, the
RADIO light will stop flashing on the original
alarm, and it will join the network. The network
is now closed.
Continue activating each new unit, one alarm at
a time, until all alarms have been added to the
network. This should include smoke, CO and heat
alarms as well.
General Note: It is easiest to first create the
radio network while all alarms are located
together, such as on a table.
The blue RADIO light will flash briefly, then the
alarm will chirp twice and all four of the lighted
icons will strobe on in succession.
Note:
This switch is connected to a lock-out
mechanism that will prevent installation on the
bracket until activated.
The slide switch will lock into place when fully
positioned.
Simply install the (3) supplied Duracell CR123
batteries as indicated on the underside of the
Speaker unit.
BedShaker Manual, Exigent Canada 2-17-16.indd 8-9 2/17/2016 5:49:08 PM