CCpilot V1000/V1200
Revision: 1.0
Technical Manual
2022-04-01
www.crosscontrol.com
8
4.
Mounting and handling
This chapter contains recommendations for installation, handling and maintenance of the
product.
4.1.
Mounting
CCpilot V1000/V1200 supports two different mounting methods, standardized VESA75 or a
panel mount. These two mounting methods are described separately below.
For both fastening methods, use the appropriate 4 pc. M6 button head screw of type MRT
(Torx) The recommended torque for the screws is 3.0-3.5 Nm. Using fluid locker or locking
washers (split ring, toothed lock, etc.) is required for proper mounting. Ensure that the M6
mounting screws are clean and dry before mounting.
Note that the depth of the threaded holes is 12mm. Be careful not to use too long screws which
may damage the device when tightened. It is also very important to use a fastening plate with
holes that are not larger in diameter than 7 mm so that the plate is flush with the threaded
inserts to avoid pulling out the threaded inserts from the unit.
4.1.1.
VESA 75 mount
CCpilot V1000/V1200 can be mounted using a RAM mount, i.e. RAM-D-2461U, square base
2.25” ball mount and accessories of choice which allows adjustment of the display’s position
and angle. Screw length should be 16mm.
Figure 4: VESA 75 mount
4.1.2.
Panel mount
Alternatively, the device can be mounted in a panel cut-out using a panel mounting bracket
(article number C000154-65)
