Crossbow Stargate NetBridge, Руководство пользователя

Страница: 9 / 62

Stargate NetBridge Gateway User’s Manual
•
Insert the included power adapter into a standard electrical outlet and plug the power
connector into the Stargate NetBridge. Upon application of external power, the Stargate
NetBridge will commence its boot procedure, it is not necessary to push the power button
at the front of the device.
2.1.2 Setting up the BU base station and SN sensor nodes (Optional)
•
If you purchased a Sensor Network base station such as the BU900, BU2110, or BU2400
with the Stargate NetBridge plug its USB cable into the remaining USB slot on the
Stargate NetBridge labeled “Disk 2”. If you are planning to add other USB devices to the
Stargate NetBridge, the “Disk 2” port can be attached to a standard USB hub which in
turn can host additional devices. Make sure that the external USB hub is powered (active)
if the attached devices exceed the power capabilities of a passive hub. Never attach the
system FLASH disk via a hub, always plug it in directly into the “Disk 1” port.
•
If you purchased the packaged SN series Sensor Nodes, they should be labeled with
Unique Node ID.
•
Insert batteries into the battery holder compartment of the Sensor Nodes and turn the
power switch to the ON position.
•
Spread the nodes around on your desk top or in the office area. Make sure that the sensor
nodes are resting on their bases with antenna pointing vertically upwards.
2.1.3 Run the GatewayConfig tool to find the IP address of the Stargate NetBridge
In order to connect to the Stargate NetBridge its hostname or IP address has to be known. The
GatewayConfig tool can help scan and find the IP address. Some networks will resolve the
hostname properly so knowing the NetBridge’s IP address is not required.
•
The hostname is determined by the prefix sluggo- and the 5-digit serial number that can
be found on the sticker attached to the bottom of the device (e.g., SN = 00006 ->
hostname is
sluggo-00006 ).
•
Enter http://hostname (e.g., http://sluggo-00006 ) into your Web browser. If the
MoteExplorer welcome screen appears you do not need to install the GatewayConfig
tool, skip to the next section.
•
Install GatewayConfig by double-clicking on GatewayConfigSetup_<version>.exe file
found on the CD.
•
The Setup wizard would guide you through the installation process. Make sure to check
all the installation options (you would need Microsoft .NET Framework 2.0)
Doc. # 7430-0449-01 Rev. A Page
3