Crossbow Stargate NetBridge, Руководство пользователя

Страница: 18 / 62

Stargate NetBridge Gateway User’s Manual
5 Data Visualization using MoteExplorer
This section describes the features of the MoteExplorer web interface included with the Stargate
NetBridge.
MoteExplorer is a web-based sensor network visualization application. The MoteExplorer
application supports Crossbow’s sensor and data acquisition boards (Table 1-1). For other legacy
boards, users should use MoteView to log and visualize data as explained in Chapter 6.
Table 5-1. MTS/MDA boards supported by MoteExplorer and their compatible Mote platforms
Mote Platforms
Sensor and Data Acquisition Boards
IRIS MICAz MICA2
MTS300/310
3 3 3
MTS300/310
3 3 3
MTS400
3 3 3
MTS420
3 3 3
MDA100
3 3 3
MDA300
3 3 3
MDA320
3 3 3
5.1 Pre-requirements
5.1.1 System Requirements
•
PC connected to the Internet.
•
Web browser, e.g. Microsoft’s Internet Explorer or Mozilla’s Firefox
•
Adobe’s Flash Player 9.x. To install Flash Player 9.x visit Adobe’s web site:
o
http://www.macromedia.com/software/flash/about/
If you are unsure whether Flash 9.x is already installed on your PC, continue with the login steps.
If Flash 9.x is not installed, your web browser will prompt you to install Flash 9.x and will lead
you through the steps to do so.
5.1.2 MoteExplorer URL
MoteExplorer is a web-based application and can be accessed through a PC’s web browser. To
access the application users will need the MoteExplorer URL address. Users can use either the
hostname of their Stargate NetBridge written on a sticker attached to one side of the device or an
IP Address. For users on a corporate or university network, the hostname should be enough to
allow users to find the application through the browser. Most home routers do not support the
means to use the hostname on the side of the box. In those cases users will need to use the IP
address of the Stargate NetBridge device.
Page 12 Doc. # 7430-0449-01 Rev. A