Cross Technologies 2115-275-1845, Инструкция по эксплуатации

Страница: 6 / 9

2.2 Rear Panel Input/Output Signals - Figure 2.1 shows the input and output connectors on the rear panel.
AC
GND
J8 J2
EXT 10MHZ
RF OUTPUT
INPUT
10MHZ REF
OUTPUT
INT EXT
AUTO
S1 J1
L-BAND
INPUT
J101
J1 - L-BAND INPUT
BNC (female) 1.345 to 2.345 GHz,
-40 to -25 dBm input level range. See
Table 2.2 for other connector options.
AC INPUT
100-240 ± 10% VAC, 47-63 HZ
Uses 2 amp Slow Blo, 5mm fuse S1 - 10MHZ (DP3T) SWITCH
3-position switch. INT selects internal 10MHz ref.
EXT selects external ref., AUTO selects internal
10MHz ref, unless a 3 dBm, 10MHz reference
signal is connected to the external reference input.
J2 - EXT 10MHZ INPUT
BNC (female) 75
Ω
. Insert external
10MHz reference here (3 dBm, ± 3 dB).
J101 - RF OUTPUT
2.92 mm (female) 50
Ω . 27.50 to 28.50
GHz, -20 to -5 dBm output level range.
See Table 2.2 for other connector
options.
J11 - PLL ALARM
DB9 (female) connector.
See Table 2.1.
J8 - 10MHZ REF OUTPUT
BNC (female) 75
Ω . Outputs currently
selected 10MHz ref signal (3 dBm, ±3 dB).
J11
ALARM
1 5 2 3 4
6 7 8 9
FIGURE 2.1 2115-275-1845 Rear Panel I/O
ʼ
s
TABLE 2.1 J1 11 TABLE 2.1 J11 Pinouts (DB9)
Pin Function
1 Not Used
2 Not Used
3 Not Used
4 Not Used
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Open
8 Not Used
9 Alarm Relay: Normally Closed
TABLE 2.2 Connector Options Connector Options
L-Band RF
BNC, 75 Ω (STD) SMA, 50 Ω (STD)
F-Type, 75 Ω SMA, 50 Ω
N-Type, 50 Ω SMA, 50 Ω
SMA, 50 Ω SMA, 50 Ω
2.3 Front Panel Indicators -The following are the front panel indicators.
DS2 - ALARM LED
Lights RED when PLL
comes out of lock. DS1 - POWER LED A
Lights GREEN when DC
voltage is present from AC
power supply. DS3 - EXT 10MHZ LED
Lights YELLOW when external
10MHz reference is active.
MODEL 2115
C
ROSS
T
ECHNOLOGIES INC.
POWER
UPCONVERTER
EXT
10MHZ
ALARM
FIGURE 2.2 2115-275-1845 Front Panel Controls and Indicators
2115-275-1845 Manual, Rev. 0 Page 6 07/20/17