Cross Technologies 2016-95, Инструкция по эксплуатации, Страница: 9 / 18

2.2 Rear Panel Input/Output Signals - Figure 2.2 shows the input and output connectors on the rear panel.
AC1 - POWER IN
AC input for switching
power supply.
100-240 ±10% VAC,
47-63 Hz.
J2 - RF IN
250 to 950 MHz input,
-70 to -20 dBm.
see TABLE 2.2.
J1 - IF OUT
70 ±18 MHz output,
-20 to -10 dBm.
see TABLE 2.2.
J10 - MONITOR AND CONTROL
DB9 female connector.
AC
GND
J18 J2
RF IN IF OUT
J10
AND
MONITOR
CONTROL
5 4 3 2
1
9 8 7 6
J3
J3 - 10MHz REF INPUT (option -E)
10 MHz external reference input,
BNC female connector.
10 MHz
EXT REF
INPUT
10 MHz
EXT REF
OUTPUT
J18- 10MHz REF OUTPUT (option -E)
10 MHz external reference Output,
BNC female connector.
J1
FIGURE 2.2 2016-95 Rear Panel I/Os
TABLE 2.1 J1 10 2.1 J 10 Pinouts (RS-232C*)
Pin Function
1 Not Used
2 Rx+ (RS-232C)
3 Tx+ (RS-232C)
4 Not Used
5 GND
6 Alarm Relay: Common
7 Alarm Relay: Normally Closed
8 Not Used
9 Alarm Relay: Normally Open
*Remote Serial Interface
Interface: DB-9 Male
Protocol: RS-232C, 9600 baud rate, no parity, 8 data bits, 1 start bit, 1 stop bit
TABLE 2.2 IFF/RF 2.2 I F/RF Connector Options Options
Option IF RF
STD BNC, 75 Ω F-Type, 75 Ω
-B BNC, 75 Ω BNC, 75 Ω
-C BNC, 75 Ω BNC, 50 Ω
-D BNC, 50 Ω BNC, 50 Ω
-K BNC, 50 Ω BNC, 75 Ω
-M BNC, 50 Ω Type N, 50 Ω
-N BNC, 75 Ω Type N, 50 Ω
2016-95 Manual, Rev. A Page 9 03/07/17