2.4 Menu Settings
2.4.1 Functions
This section describes operation of the front panel controls. There are three ope rator switches, the LCD display
and alarm indicator LEDs. All functions for the equipment are controlled by these components. The functions
are (see Figure 2.3):
Power Up
Normal Display
Menu 1 Manual
Select
Menu 2 Remote
Enable
Menu 3 Interface
Menu 4 RS-485
Address
Menu 5
Minimum Auto Switching
Save Menu When “R” is selected in any above menu, or when the end is reached (after Menu 11)
All program changes must start with the operation of the Menu/Execute switch and must also end with the
operation of the Menu/Execute switch verified by the “Save Settings?” Menu. If this sequence is not followed,
none of the changes will take effect. If programming is initiated and no operator action takes place for
approximately 12 seconds (before the final press of the Menu/Execute switch) the display will revert to its
previous status and you will need to start over.
1582-10 Manual
Page 10
1/22/09
