Rev D
Model MS-500x
CrossPoint Technologies, Inc
11
Maintenance & Setup
This top level menu item allows the setup of the serial port, and allows reading the software
version identifier.
Maint & Setup
ENT: Select ESC: Quit
UP IN MENU 1 2 3 4 5 ESC
DN OUT OFF 6 7 8 9 0 ENT
FLT PS
Press ENT to drop into the menu and scroll through the choices.
CAUTION
If any of the serial or Ethernet settings are changed, when the
user navigates back to this top level menu item, the switch matrix
will reset itself and begin using the new parameters. Switch
matrix connections
will be interrupted
while this reset takes
place, and will then be automatically restored. Reset typically
takes less than 10 seconds, depending on network response
times.
Serial Options
All serial communication settings are made from these menu items. Press ENT to drop into these
items
Serial Options
ENT: Select ESC: Quit
UP IN MENU 1 2 3 4 5 ESC
DN OUT OFF 6 7 8 9 0 ENT
FLT PS
The default RS232 mode is shown here.
COM Mode: RS232
ENT: Select ESC: Quit
UP IN MENU 1 2 3 4 5 ESC
DN OUT OFF 6 7 8 9 0 ENT
FLT PS
Pressing ENT will allow scrolling through the other choices. RS422 and (future) Ethernet are
selected from this menu. To select RS422, use UP/DN until the screen shows RS422. Press ENT
to change the interface. Changing Serial mode parameters will cause the Matrix to reset itself
automatically when the action is confirmed, and will be operational again in about 6 seconds.
