Crosley Director CR2405A, Инструкция по эксплуатации

Страница: 6 / 8

12
Getting Started
Unpacking................................. 4
Power Source........................... 4
Control Locators.......................
5-6
Basic Operation
General..................................... 7
Radio Operation....................... 7
Turntable Operation.................. 8
Cassette Operation..................
8
CD Operation
Playing a CD............................... 9
Programmed Playback................ 9
Playing MP3 CD’s...................... 10
Recording records to CD........... 11
Recording cassettes to CD........ 11
Erasing CD-RW CD’s................. 12
Audio / Connections
Audio.......................................... 13
General
Troubleshooting Guide................ 14
Warranty....................................... 15
About This Manual
Thank you for purchasing the Crosley Director
(CR2405A). Before operating this unit, please read
this manual thoroughly and retain it for future
reference.
Instructions in this manual describe the control
functions of the CR2405A.
Included in the package:
Welcome
Table of Contents
Director
Remote Control
45 RPM adaptor
You can divide your recording into separate tracks
if you wish. By doing this, each song will have its
own sequential track number. To do this, you must
use the SPLIT TRACK button (6/56).
While Recording your record , listen for the end of
each song. There will usually be a brief silence
between songs. Once you are at the end of the
song, press the Split Track button. The recording
will then go to the next track number by increments
of one. Once the recording is finished, you can press
the (11/64) or the (8/52) buttons to go to
the beginning of each song.
If using a CD-RW, you can erase the whole CD and
rerecord it. Erase procedures are only possible with
CD-RW discs. It is not possible to erase or rerecord
a CD-R CD. To erase a CD-RW, follow the steps
below.
1
Press the FUNCTION button (2/68) to set the
unit to CD mode.
2
Load a recorded CD-RW into the unit.
3
Press the STOP button (12/53) to stop playback.
4
Press the ERASE button (3/57). ERASE / Y will
appear on the display ,Press PLAY Button(14/63)
to confirm and the erasing process will begin,if
cancel please press the STOP Button(12/53) .
When finished, the display will first read “F Done”
and then “BLANK CD”.
5
The CD is now ready to record.
NOTE: Once a CD is erased, the contents that were
on the CD cannot be retrieved.
CD Operation
Manual Track Division
Erasing a CD-RW