Crosley CFWH4084GW, Инструкция по использованию и уходу

Страница: 20 / 60

20
All detergent level status
lights are lit (on some
models) (cont.)
Detergent Level sensor error. Touch POWER to reset system. If all detergent status LEDs
remain lit, unplug washer for 30 seconds; then plug back in.
If problem remains, remove cartridge and use single load
dispensing until problem can be resolved.
F# E# or F## E##
code
other than as described
above appears in display
System error code. Touch POWER once to clear the code. Then touch POWER
again to restart washer. If code appears again, call for service.
Unplug washer for 30 seconds; then plug back in.
Washer making error
beeps
Door has not been opened and
closed for at least 3 cycles.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Washer beeps when
START is touched
Door not closed. Close the door completely.
Clean Washer LED flashing
at end of wash cycle
(on some models)
The washer has run 30 wash cycles
and is indicating a reminder to run the
Clean Washer with affresh
®
cycle.
Run the Clean Washer with affresh
®
cycle. If the Clean Washer
with affresh
®
cycle is not turned on, the LED will stop flashing
at the end of a wash cycle after running 3 more regular wash
cycles. After 30 more wash cycles are completed, the Clean
Washer with affresh ® LED will again flash at the end of a wash
cycle as a reminder.
Troubleshooting
If you experience Possible Causes Solution
Error Code Appears in Display (for 2 and 3 digit displays) (cont.)
All detergent level status
lights are lit
(on some models)
Detergent dispenser is not securely
in place.
Pull out the dispenser, fill with detergent, and slide it back
in place.
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help –
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.