E9
CRL Unica hydraulic hinge 100E10
For more information Freephone UK and Ireland on 00 800 0421 6144 | Fax free on 00 800 0262 3299
Enter the door, possibly sloping for easier insertion.
Then place the notch in the hinge seat.
Slide the cover on the hinge body.
Act on the four lower grains to adjust the alignment of the door (± 30mm with a
1000mm reach). Once aligned block the screws
Use the gasket supplied to compensate for different thicknesses of
glass (1) and tighten the 4 screws with (Ch3) key (2). See table.
Secure the covers by unscrewing the eight screws on
the body.
Cover with screw-cover plates.
FUNCTIONING RANGE
Area wich is
controlled from the
hydraulic system
Area of closing speed adjustment
Area wich is
controlled from the
hydraulic system
Area wich is not controlled
from the hydraulic system
STARTING RANGE
STARTING RANGE
Area wich is not controlled
from the hydraulic system
For Glass
SIDE OF GLASS BLOCKING PLATE
1 gasket 0,5mm
BODY’S SIDE
1 shaped gasket
For Glass
SIDE OF GLASS BLOCKING PLATE
1 gasket 0,5mm + 1 gasket 1mm
BODY’S SIDE
1 shaped 1 gasket 1mm
For Glass
SIDE OF GLASS BLOCKING PLATE
1 gasket 0,5mm
BODY’S SIDE
1 shaped 2 gasket 1mm
Installation and adjustment instructions
CRL Patch Fitting Hydraulic Door Hinge
Adjust the final click strength with (Ch3) key acting on the
nozzle denoted by the letter “S” with the door open to 45
degrees. Turn clockwise to decrease the force and
counter-clockwise to increase it.
Adjust the closing speed with (Ch3) key acting on the
nozzle denoted by the letter “V” with the door open to 45
degrees. Turn clockwise to reduce speed and
counterclockwise to increase it.
