17
GB/IE
Pinlock
®
30
The plastic lens in the Pinlock
®
visor absorbs moisture . The air
pocket between the lens and visor reduce the
difference between the temperature inside the
helmet and the outdoor temperature .
Integrated sun shield
High-strength
HCM outer shell
High Density Copolymer Matrix:
High quality ABS plastic is
formed under extreme heat and
pressure to make a robust and
impact-resistant outer shell .
Anti-scratch coated
visor
Separate winter
comfort collar
Removable,
washable liner
Toolless visor changes
With an additional set
of cheek pads for a
custom fit
Suitable for
eyeglass wearers
Safety lock closure
Use and Installation
Instructions
Sun Shield (Fig. C)
The integrated sun shield (10) will enable you to
quickly and easily react to changed light condi-
tions with the aid of the patent mechanism .
To pull out and retract the sun shield, press the
safety latch to operate the slider (5) .
Note:
• Please take care that the edge of the sun shield
does not block your field of vision .
• The sun shield may only be used when the visor
is closed and may only be used during the day .
Inner Lining (Fig. D)
The inner lining (15) can be completely removed
and cleaned separately (see care instructions) .
To remove the inner lining, firstly remove the
helmet collar and the cheek pads . Then undo the
back press-studs of the inner lining and pull the
clips of the inner lining from the front side of the
helmet .
Snap-Fastener System (Fig. E)
The snap-fastener enables an individual and
quick vernier adjustment of the chin strap .
Press the snap-fastener together until the helmet is
sitting comfortably but firm .
The movable buckle may be used to fasten or
secure excess chin strap .
Chin-Wind Deflector (Fig. F)
The chin-wind deflector (12) is secured to the
pivoted piece by means of snaps .
This can be removed and re-attached as
required .
Cheek Pads (Fig. G)
You will receive two different pairs of cheek
pads (14) for individual size adjustment .
The thinner cheek-pads are already pre-mounted
as standard . The thicker cheek pad is enclosed
with the helmet separately .
If the helmet is too loose and therefore is not sit-
ting firmly on your head, you can replace the thin
cheek pad with the thicker ones .