English
29
7.2 Unit control panel
The display of the unit is programmed to turn off
automatically after 20 seconds of non working.
To activate it just press “UP” “DOWN” “UP” “DOWN” keys.
When the display is actice, the luminous intensity is dim-
mered to 10% in order to avoid blind effect.
In the presence of DMX signal, the DMX led (right decimal
point) will be steady on, in the absence of signal, the red
led will be off, while in Master mode the red led will flash.
The SET led (left decimal point) is on during:
• DMX address is setting
• menu setting
7.2.1 Reading the display and using controls
MENU
button:
By pushing the “MENU” button the display will show the main menu or you can exit from function and go back to
main menu.
By pushing the “MENU” button when is show the DMX address, you will enter in the main menu.
• address setting
ADR
• channels number setting
CHN
• MASTER/SLAVE and AUTOMATIC mode
AUT
• FIXED COLOURS mode
COL
• LED temperature
TEM
• Default setting
DEF
• Software release
REL
UP
and
DOWN
buttons:
By pushing the “UP” and “DOWN” buttons, values of the function which is shown in the display can be changed.
ENTER
button:
Keep the “ENTER” button pushed, until the display and the SET led flash, in order to memorize the function which
is shown on the display.
8.1 Setting DMX channels
The number of DMX channels used by the unit to operate will depend from the selected operating mode.
Each unit will use
4, 5 or 6
DMX channels.
Follow this description to modify the DMX channels setting: press the “MENU” button, select “CHN” and press
“ENTER” button to activate the function. Then select the desired value (4C, 5C, 6C) through the “UP” and “DOWN”
keys. Press “ENTER” to confirm.
In case of more units operating in 4 DMX channels mode, the first unit will be set with address 001, the second unit
with address 005, the third unit with address 009, etc.
In case of more units operating in 6 DMX channels mode, the first unit will be set with address 001, the second unit
with address 007, the third unit with address 013, etc.
8.2 Setting DMX address
Follow this description to modify the address: press once the “MENU” button, select “ADR” and press “ENTER” but-
ton to activate the function. Then select the desired value (between 1 and 512 ) through the “UP” and “DOWN”
keys. Press “ENTER” to confirm.
8.0 DMX function mode
