Cristofoli Ultrasonic cleaner, Руководство пользователя

Страница: 12 / 16

12
CRISTÓFOLI
U L T R A S O N I C C L E A N E R
I N S T R U C T I O N M A N U A L
For any replacement of parts, contact your local retailer or an authorized Cristófoli representative. It’s strongly not
recommended the replacement of any parts by non-qualified people.
We have listed below the most frequent problems and possible solutions the operator can try in his/her own office.
TROUBLESHOOTING
If the problem persists after the verification of all the items listed, contact your local retailer
or an authorized Cristófoli representative.
•
·The equipment may be 220V and be connected to
a 127V power outlet ----------------------------------------------
•
·Damaged circuit board --------------------------------------
•
·See that the necessary arrangements for the electrical wiring
are made as shown on item “ Installation Instructions ” (Page 5).
• See “ Authorized Technical Assistance ” (Page 13).
• ·Plug the power cable on both ends, the power connector of the
cleaner and the wall outlet (Fig. 9, page 8).
•
See “ Authorized Technical Assistance ” (Page 13).
• ·Check if there’s a power outage in your building.
• ·The equipment is not plugged in ----------------------------
•
· -------------------------------------------------- Burned out fuse
• ·No power --------------------------------------------------
THE ULTRASONIC CLEANER DOES NOT TURN ON
LOW CAVITATION OR NO CAVITATION AT ALL
•
See “ Authorized Technical Assistance ” (Page 13).
•
· ---------------------- The heating element has burned out
POSSIBLE CAUSES SOLUTIONS
POSSIBLE CAUSES SOLUTIONS
POSSIBLE CAUSES SOLUTIONS
THE ULTRASONIC CLEANER TURNS ON BUT THE HEATING DOES NOT WORK
• · The transducer burned out because of the lack of
water in the vat or incorrect voltage installation -----------
• See “ Authorized Technical Assistance ” (Page 13).