Read this instruction sheet completely and your monitors instructions before beginning the
installation.
Note: Most License plates do not require modification. However, please look over camera
mounting and placement options prior to making modifications to vehicle.
Step 1.
Remove license plate, if necessary cut or file a ¼ slot above the license plate mounting holes
as shown below.
Step 2.
Install the License plate bar camera over the face on the top edge of the license plate; make
sure the screws are secure.
DO NOT OVER TIGHTEN!!
Over tightening may damage the camera
mounting hole locations.
Step 3.
Wire connections:
Camera’s Yellow socket is connected to video input on monitor unit; Black socket is for the power
connected to DC 12V.
A. Connect the yellow (RCA) socket to video monitor input connection, and the black socket to the
video monitor power output connector, if the Rear view monitor unit has auto reverse camera
power on feature.
(See Wiring Diagram1.)
