CrimeStopper SecurLinc CS-2008PC, Инструкция по установке и эксплуатации

Страница: 7 / 19

SHOCK SENSOR
DUAL ADJUST Smart Sense™ Shock Sensor:
GREEN
RED
Pre-Warn
Trigger
The supplied dual stage / dual adjust shock sensor does not require
any additional wiring. Just mount the sensor, plug in the “Sensor #1”
input plug on the 2008PC harness and adjust to the desired levels of
sensitivity for pre-warn and shock sensor violations. Use the Green
dial for pre-warn and the red dial for shock trigger. Note the shock
sensor can also be adjusted the remote control. You can also test &
adjust the sensor (s) using your remote control. See below.
SENSOR ADJUSTMENT WITH REMOTE CONTROL:
1. Turn Ignition ON and press button #5 (side button) on the
your remote control 3 times, then press Button #3 (Trunk
Symbol).
2. The siren will chirp 4 times indicating that the system is in
Sensor Adjust mode.
3. You can now carefully produce some vibrations or impacts around the vehicle such as kicking a tire or
slapping a bumper. When you produce an impact that would normally trigger the Pre-Warning level,
the siren will chirp twice. When you produce an impact that would normally trigger the shock sensor,
the siren will chirp once. If you are using a 2
nd
sensor and you trigger that sensor, you will hear 3 chirps.
4. When finished testing and adjusting the sensor (s), turn Ignition OFF, then back ON to clear this mode.
LED / VALET “POD”
Mount the LED / Valet button POD in a visible & accessible
location. Note: you can increase security of the exposed
valet button by personalizing your override code. See page
14 for instructions on changing your override code.
LED
VALET/PROGRAM
BUTTON
SYSTEM
LED POD
MOUNTING INSTRUCTIONS:
DASH UNDER
IN DASH
Use
"L" Bracket
-OR-