background image

**Some of the features listed above are optional connections, and may require additional parts and labor.** 

 
 

INSTALLATION CONSIDERATIONS / WARNINGS 

 
 

TECHNICAL SUPPORT: 1-800-998-6880 

Monday - Friday 8:00am - 4:30pm Pacific Time 
Web Site: www.crimestopper.com 
E-mail: [email protected] 
CRIMESTOPPER SECURITY PRODUCTS, INC. 
1770 S. TAPO STREET, SIMI VALLEY, CA. 93063 

 
 
 

To ease and reduce installation time, we suggest you consider the following points before starting. 

 

1. Determine most suitable locations for all components to be placed. These components include:  the module 

itself, override / programming switches, and possible relays. 

2. Use a Volt-Ohm meter to test and locate all connections. 
3. Record all color codes of vehicle wiring to be used for reference. This will save time by not having to re-test the 

same wires over again. 

4. Allow enough wire to create a service loop with strain relief, should servicing be required.  This will also allow 

easier access and mounting. 

 

**FOR SAFETY REASONS, DO NOT INSTALL RS900/901 in vehicles with MANUAL TRANSMISSIONS

.**  If 

accidentally left in gear, a remote started vehicle could become a self-propelled threat to life and property. 

 

DO NOT

 extend the RS-900 Remote start ignition harness length.  Mount the module so that main harness reaches 

all ignition switch wiring.  Extending these wires could result in poor performance. 

DO NOT

 route any wiring that may become entangled with brake, and gas pedals, steering column, or any other 

moving parts in the vehicle. 

DO NOT

 exceed the rated output current of any circuit on the Remote start module.  Failure to observe this warning 

will result in damage to the unit. 

DO NOT

 remote start the vehicle in a closed garage.  Make sure that the garage door is open or there is adequate 

ventilation.  Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes. 

 
 
 

This device complies with FCC Rules part 15.  Operation is subject 

to the following two conditions:  (1) This device may not cause 

harmful interference, and (2) This device must accept any 

interference that may be received, including interference that may 

cause undesired operation.  The manufacturer is not responsible 

for any radio or TV interference caused by unauthorized 

modifications to this equipment.  Such modification could void the 

user’s authority to use the equipment. 

Warning:

  This system DOES NOT HAVE engine over-rev protection.  Make certain 

vehicle throttle linkage operates properly and does not stick.  A stuck throttle will 

Содержание RS-900ER.II














Отзывы: