The channel ON and OFF
buttons set each individual
channel state. If a channel is
set to OFF, it is taken out of
the bracketing (ALL) mode, it
is not fired by camera sync
and all commands are
ignored except ON.
Backlit Liquid Crystal Display (LCD)
indicates exact settings of flashpo wer,
bank / channel information,as well
as specific model lamp status.
Bargraph indicator shows channel
flashpower settings at a glance .
Pressing a FLASHPOWER but-
ton raises or lo wers flashpow-
er. Increments in 1 f-stop
(double-arrow) units or in
1/10 f-stop (single-arrow)
units.
Pressing and holding BANK
while pressing up/down
arrow CHANNEL buttons
selects from Bank 1 to 16.
Pressing the up/down arrow
CHANNEL button selects 1 of
16 possible channels.
The MODEL select button
scrolls through the three
possible model lamp states -
ON,OFF or TRACKING mode .
The current MODEL status is indicated by the
Model Lamp icon in the LCD window.
WHITE LIGHTNING
RadioRemote One
Wireless Remote Control System
(Includes Instructions for RadioRemote One Transmitter and RadioReciever One)
10 / 1999
Paul C. Buff, Inc. / WHITE LIGHTNING / 800-443-5542
2725 Bransford Ave. • Nashville,TN 37204 • USA
fax: 615-383-0676 • website: http://www.white-lightning.com
F-VALUE is a two-digit display showing channel flashpower
in 1/10 f-stop units. Range is from +0.0 to -6.2 f-stops.
BANK/CHAN display shows
current channel.While pressing
BANK button,display shows
currently assigned bank.
When using (ALL) mode, dis-
play shows if a channel is over
or under range by indicating
lowest numbered channel out-
of-range.
ALL channel mode indicator
becomes active when pressing
and holding the ALL button.
Used for bracketing scenes
while maintaining lighting
ratios.
The MODEL lamp icon indi-
cates one of three states -
ON = blank, OFF = dark,and
TRACKING = half-bulb.
Pressing the ALL button once
sends the current settings to
all lights. Pressing and holding
the ALL button together with
any FLASHPOWER button,rais-
es or lowers all channels’ flash-
power (unless a channel is out-
of-range - see text)
Pressing FIRE test flashes the
channel number currently displayed in the CHAN
window. Pressing ALL before, either once or holding,then
pressing FIRE test flashes all lights in system.
TRANSMITTER
