6
TRANSMITTER PROGRAMMING
Note: Programming of Data Module to vehicle must be completed FIRST!
The system learns up to 4 different transmitter codes.
There are 2 methods of programming remotes depending on the Data module used to operate your vehicle.
ADS iDatalink Programming:
1.
Insert key fob into Keyport or place key in ignition switch. Complete step 2 within 7 seconds.
2.
Cycle the ignition on five times (5x Off/On) rapidly.
3.
Parking Light will flash once (1x). Complete step 4 within 5 seconds.
4.
Press Lock (or start on 1 button remote) button on remote you wish to program.
5.
Parking lights will flash once (1x) to confirm the remote is programmed.
6.
To program additional remotes, repeat step 4 & 5. The system can accept up to 4 remotes.
7.
The system will automatically exit remote learning procedure after 5 seconds of inactivity and the parking
lights will flash twice (2x) to confirm programming exit.
Fortin EVO-ALL Programming:
1. Put the EVO-ALL in programming mode (see install guide), release programming button on BLUE/RED.
2. Press and hold the programming button on EVO-ALL for 5 seconds. The 2 LED’s will shut down and turn
back ON after 5 seconds.
3. Turn the Ignition ON.
4. Press the “Lock or Start” button on remote you wish to program.
5. The BLUE and RED LED’s will flash once to confirm remote is coded.
6. To program additional remotes press the Lock or Start button of each remote.
7. The BLUE and RED LED’s will flash once to confirm each remote is coded.
8. Turn Ignition OFF once all remotes have been programmed.
Содержание REVO-1 Series
Страница 7: ...7...
