REMOTE ENGINE CONTROL
INFINITY RUN MODE
This mode can only be activated when "Idle Down" procedure. The Infinity Run mode allows the vehicle engine to
remain running
INDEFINITELY after the programmed run time elapses
. This mode will allow the vehicle to be left
running and unattended
without
the ignition key in the switch preventing the vehicle from being stolen. This mode
can be beneficial to law enforcement or commercial vehicles that need to remain running unattended for long
periods of time.
INFINITY RUN MODE – EXITING THE VEHICLE:
1) With vehicle engine running with the key, press the Remote Start button for at least 1 second, pause a few seconds,
then press and release the remote start button a second time.
2) Parking Lights will start flashing, and doors will unlock.
3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running.
4) The vehicle’s parking lights will flash for the programmed run time of 12, 24, or 36, or 48 minutes and then switch to solid
while motor runs indefinitely or until fuel supply runs out.
ENTERING A VEHICLE DURING IDLE-DOWN or INFINITY RUN MODES:
See “Entering Your Remote Started Vehicle” on Last page.
SELECTABLE HOURLY COLD-START MODE (1-4 HOURS)
This mode allows the vehicle to be programmed to self-start every 1, 2, 3 or 4 hours and run for the programmed
run time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern.
THE
VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA!
Once this mode is set, the unit will start at
the programmed hourly interval and run for the programmed run time. To reset this mode, either start the vehicle
with the key or the remote control.
SELECTABLE HOURLY COLD-START MODE – EXITING THE VEHICLE:
1) Engine should be running with the Key. Press the Remote Start button for at least 1 second. Lights will turn on signaling
the remote start has turned on and doors will unlock.
2) Within 10 seconds press and release the valet/program button once for each hourly increment (1 time = 1hour, 2X = 2
hours, 3X = every 3 hours, 4X = every 4 hours).
3) Parking Lights will turn off once the button is pressed and flash for each consecutive button press.
4) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running.
5) Once outside the vehicle, press and release the remote start button to turn off engine. The parking lights will flash the
number of times indicating the hourly increment for final confirmation.
6) The vehicle will start by itself at the selected hourly increment until driven with key or started by the remote.
6
