Technical Solutions Australia Pty Ltd
Technical Solutions Australia
Ph 03 9737 9000 Fax 03 9737 9111
www.tecsol.com.au
This remote control unit has an effective range of about 7 metres. Ensure that the remote control unit is directed
at an angle of less than 30 degrees to the equipment for the best results.
Before using, load 1.5 Volt batteries type AAA , SUM4 or
RO3 into the unit. Proceed as follows:
NOTE: When loading, check that the polarity of the batteries
is correct.
When replacing, always use batteries of the same type. If the
remote control is not to be used for a long time it is advisable
to remove batteries to prevent damage caused by leakage.
Dispose of used batteries properly. Always change all four
batteries at the same time.
The batteries must be changed within two minutes otherwise
the memory of the URC 905O is erased
.
COMPONENTS OF THE URC 9050.
1. LED indicators These light up when you use one of the following functions:
A) LEARN Indicator: This lights up when the LEARN KEY (3) is pressed and indicates that the URC
9050 is ready to “learn”.
B) SEND’G Indicator: This lights when a signal is
transmitted. In the LEARN mode this indicates that the
input message has been recorded.
C) DELETE Indicator: This lights up when the DELETE
KEY(5) is pressed and shows that information can be
erased.
D) ERROR Indicator: This lights up when the DELETE
KEY (5) is or when there is no signal under the key you
have pressed.
E) BATT. LOW Indicator: This lights up when the batteries
need replacing.
2. Memory Bank Selector. This allows you to select the data-bank
you require. You can choose from six different banks TVI, TV2,
VIDEO, AUDIO, CD, AUX
3. LEARN Key This is used to switch the Learn/Copy mode on
and off.
4. MACRO
Key This key allows you to program more than 10
commands under 1 key, so when that key is pressed, all
programmed functions are switched on.
5. DELETE Key Use this key to delete the
data of a key.
6. Programmable Keys All these
32
keys can be’ programmed
with a signal devised by you. In order to improve ease of use
we have already given the keys the most useful symbols. You
can also put your own signs in the space above the keys. To do
this, use a pencil to lift the plastic protective cover from the key-
board and then
use a pen to mark the relevant key.
7. Hole for
removing plastic protective cover
.
8. Infra red transmitter window. Point this end at the appliance to
be controlled.
9. Infra red learning window. When training, point the sample
remote control into this window.
USING THE URC 9050
PROGRAMABLE REMOTE
CONTROL
