8
TURBO TIMER MODE (OPTION #22)
The optional Turbo Timer mode allows the CoolStart system to keep a Turbo or Turbo Diesel vehicle running for 1
to 5 minutes [selectively] after you remove the key and exit the vehicle. This is handy for turbo cool-down without
the need for expensive turbo timers. This mode requires the use of an extra part called a momentary switch/button
that is not included with the kit. There are (3) modes of operation for the Turbo Timer Mode
1.
Brake Pedal Set Mode
. With the engine running by key,
press Remote Start Button with brake pedal
depressed.
As you release the brake pedal, the Parking Lights and Status LED will blink the number of
minutes for the Turbo Timer setting. The doors unlock after confirmation. The run time can be changed by
using the push button switch attached to the green start activation wire (see Always Set Mode).
2.
Always Set Mode (default)
. The Turbo Timer Run Time must always be set. With brake pedal depressed
and engine running by key, Press the “Turbo Timer” button 1 to 5 times for each minute of run time you
desire. (1 press = 1 min.) As you release the brake pedal, your system will confirm by flashing the lights the
same number of times the button was pressed. The doors unlock after confirmation. Turn Ignition switch OFF,
remove key and exit the vehicle.
3.
Idle Down Mode.
This replaces the normal Idle Down Mode. Can’t use Infinity Run or Manual Transmission
Mode with this option.
With the engine running by key, press the Remote Start Button.
The Parking Lights
and Status LED will blink the number of minutes for the Turbo Timer setting. The doors unlock after
confirmation. The run time can be changed by using the push button switch attached to the green start
activation wire (see Always Set Mode).
Note:
Mode 1 and 3, the run timer (1 to 5 min.) is set one time. The system always remembers the Turbo Timer
setting even with battery disconnection.
