13
Plug-In Red LED Status Indicator Light
The Red LED Status Indicator Light visually confirms the status of the system
and provides a high level of visual deterrence. The LED should be mounted in
a location where it can be easily seen by the driver, as well as from outside the
vehicle. Good mounting locations differ from vehicle to vehicle, but generally
a spot on the driver’s side or optimally in the center of the dash will suffice.
When mounting, we suggest checking for a blank, or "dummy" plate, such as
used to fill an opening where optional switches or accessories would normally
be located. Drilling into a large, expensive to replace piece of the dash should
be avoided. The correct size mounting hole is 5/16".
The safest, most accurate way to drill the hole is to use a stepped drill bit, such
as a Unibit. Drill in steps until the hole is the proper size. If using a single-sized
bit, use a 1/8", then a 1/4", then a 5/16" bit to prevent the drilled material from
cracking or splitting. After mounting the LED, route the Red connector to
security system control module and insert into the Red plug on its side.
CAUTION! Check behind the panel being drilled into for obstructions before
drilling! Taping the bit will prevent excess penetration.
Plug The White 2-Pin Connector Into The White 2-Pin Port On The Security
System Control Module.
Plug-In
LED
Status
Indicator
B l a c k
Wire
Red Wire
Vehicle's
Dash, Into
Blank
Plate If
Available.
