GLASS DRILL INSTRUCTION MANUAL
CRIMPING TOOL INSTRUCTION MANUAL
crlaurence.com
C.R. Laurence Co., Inc.
•
2503 E. Vernon Ave., Los Angeles, CA 90058
•
1.800.421.6144
•
crlaurence.com
P. 9
JULY 2020
C.R. Laurence Co., Inc.
•
2503 E. Vernon Ave., Los Angeles, CA 90058
•
1.800.421.6144
•
crlaurence.com
OPERATING INSTRUCTIONS
Read the entire SAFETY INFORMATION section at the beginning of this manual including all text under subheadings
therein before using this product.
Please do not knock any part of the tool, otherwise it is dangerous for operator.
1. Select the appropriate die set. Ask an authorized facility or distributor to choose proper compression
die set for the connector and cable being used.
Don’t operate the tool without dies.
2. Insert the upper crimping die and the down crimping die to match the die holder when both die halves are in place.
3. Make sure both dies halves are secured before operating the tool.
4. Fully insert the cable into the barrel of the connector.
5. Place the connector between the dies. Pump the handle until it reaches the maximum pressure, then spin the dial to
release the pressure manually.
DANGER
WARNING
CAUTION
DANGER
WARNING
CAUTION
Insert
the die.
