Crestron TPS-ENETL, Руководство по эксплуатации и установке

Страница: 20 / 32

Ethernet Card for TPS/Lectern Panel Crestron TPS-ENETL
Ethernet Setup
Ethernet configuration is only performed via the touchpanel remote
console mode and is not available through Viewport setup screens. This
section contains the console commands required to setup the TPS
touchpanel(s) for Ethernet operation. To setup the touchpanel for
Ethernet operation, perform an appropriate section of “Obtaining
Communication” on page 11, then enter the desired commands. An
example Ethernet setup is described on page 17. When in remote console
mode, Viewport will display <TPS at the command prompt.
NOTE: Console command help is accessed several ways. Typing “ ?”
displays the help main menu, “ help” displays a description of the help
system, and typing “help all ” displays all console commands with
detailed descriptions and other relevant information. Help for individual
commands is available by type the command followed by a “?”, (i.e.
ADDMASTER ?).
NOTE: To enable the keystroke echo in the console, press “ENTER” or
“RETURN” as the first keystroke. Otherwise, the keystrokes will not be
displayed.
NOTE: The IP Address, IP Mask, and Default Router for the touchpanel
must be obtained from an MIS Department or other Network
Administrator. Refer to the latest revision of the Crestron e-Control
Reference Guide (Doc. 6052) for term (IP Mask, Default Router, etc.)
definitions. The latest version can be obtained from the Downloads |
Product Manuals section of Crestron’s website (
www.crestron.com) .
NOTE: For Ethernet communication, IP tables must be set up in the
control system and touchpanel. Refer to the “IP Table Setup” section of
the latest revision of the Crestron e-Control Reference Guide (Doc.
6052). The latest version can be obtained from the Downloads | Product
Manuals section of Crestron’s website (
www.crestron.com) .
NOTE: Some of the specific console commands are listed on the next
page. For a complete listing and description of each, refer to the latest
version of the 2-Series Console Commands Reference Guide (Doc. 6002)
available from the Downloads | Product Manuals section of the Crestron
website (
www.crestron.com) .
16
•
Ethernet Card for TPS/Lectern Panel: TPS-ENETL Operations & Installation Guide - DOC. 6013