Crestron TPS-ENETL, Руководство по эксплуатации и установке

Страница: 21 / 32

Crestron TPS-ENETL Ethernet Card for TPS/Lectern Panel
Console Commands for Ethernet Setup
ADDMASTER IPMASK
DEFROUTER IPTABLE
IPADDRESS REMMASTER
As an example of an Ethernet setup, a TPS touchpanel is connected to a
PRO 2 via Ethernet. The PRO 2 is at IP Address 192.168.0.1. The TPS
panel is at IP Address 192.168.0.2. The PRO 2 has the TPS panel defined
on CIP ID 05. There is no default router required. The IP Mask for the
network is 255.255.255.0. The TPS panel would need the following
commands typed in at the console and then rebooted.
NOTE: A TPS touchpanel can communicate with up to 252 masters
(control systems).
ADDMASTER 05 192.168.0.1 Adds control system IP address to
touchpanel IP table.
DEFROUTER 0.0.0.0 Sets router IP address on the system.
IPADDRESS 192.168.0.2 Sets touchpanel IP address.
IPMASK 255.255.255.0 Sets subnet mask for LAN to which the
touchpanel is attached.
Communicating with the Touchpanel via
Ethernet
After Ethernet parameters have been configured on the touchpanel, the
Crestron Viewport may be used to communicate with the touchpanel. To
connect the Viewport to the touchpanel, perform the following
procedure.
NOTE: Make sure the remote console is disconnected.
1. In the Viewport, select Remote | TCP/IP | Connect as shown
on the next page. The “Crestron Viewport TCP/IP Connect”
window appears.
Operations & Installation Guide - DOC. 6013 Ethernet Card for TPS/Lectern Panel: TPS-ENETL
•
17