Crestron TMK-4L, Руководство по установке

Страница: 8 / 16

Trim Ring Mount Kits Crestron TMK-4L & WMKT-4L
Drywall Cutout Template and Dimensions (supplied with WMKT-4L only), 2 of 2
6 3/4 in
(172 mm)
TEMPLATE – OV40086
FOR WMKM-4L OR WMKT-4L ONLY
2 OF 2
3/4 in
(19 mm)
4 1/16 in
(103 mm)
3 13/16 in
(97 mm)
1/4 in
(5 mm)
5 9/16 in
(141 mm)
9/16 in
(14 mm)
5 5/8 in
(143 mm)
4 5/16 in
(110 mm)
1 5/16 in
(33 mm)
Installation
This section provides an installation procedure for each Trim Ring Mount Kit. The
“TMK-4L Procedure” starts below and the “WMKT-4L Procedure” starts on page 6.
Be sure to review each procedure before starting.
TMK-4L Procedure
This section provides the necessary steps for the assembly of the TMK-4L with
either the BB-4L or PMK-4L. It is assumed that the BB-4L or PMK-4L has been
secured to the stud according to the instructions in the latest revisions of their
Installation Guides (Doc. 6387 and Doc. 6388 respectively). It is also assumed that
drywall is in place and a rectangular cutout for the touchpanel is made in the drywall.
Complete the steps in the order provided. The only tool required and not supplied is
a level.
CAUTION: Allow an air gap of at least 12 inches (30.48 cm) in the wall cavity
above and below the touchpanel for heat dissipation.
NOTE: When installing into the PMK-4L, verify that the 18 AWG bus wire
securing the cables for the touchpanel remains attached.
1. Verify that the rectangular cutout in the drywall is as level as possible.
2. Insert the symmetrical trim ring into the opening, as shown in the
illustration on the following page.
4
•
Trim Ring Mount Kits: TMK-4L & WMKT-4L Installation Guide – DOC. 6390A