Crestron Prodigy PMC2, Руководство пользователя системы

Страница: 46 / 74

Prodigy™ Media System Crestron PMC2
1. With the mode selection switch in the RUN position, adjust
the lighting level to the desired level.
2. Move the mode selection switch to the SET position.
3. Press and hold the upper part of the large button until the
LED on the dimmer blinks.
4. Set the mode selection switch to the RUN position.
•
When the mode selection switch is set to OFF , the large button will
not have any function and the load is disconnected from the power
source. This
must be used when changing light bulbs to ensure that
the load is fully disconnected from power. Any P-CBD devices that
control the same load will not perform any function.
P-SWRF Wall Switch The P-SWRF has a mode selection switch labeled RUN SET OFF .
Depending on the setting, the P-SWRF will perform different functions.
P-SWRF
•
The RUN position is used to turn the light on or off. When the mode
selection switch is in the RUN position, the switch operates as
follows:
To turn on the light, tap the upper part of the button again.
⇒
⇒
To turn off the light, tap the lower part of the large button. If
the switch has a delay before turning off the light, tap the
lower part of the large button again.
•
When the switch is in the SET position, the dimmer can store a delay
time before turning off the light. To store a time delay:
1. Move the mode selection switch to the SET position.
2. Press and hold the upper part of the large button for the
amount of desired time delay. For example, holding the
button for 10 seconds will set a delay of 10 seconds from the
time the lower part of the button is pressed until the
controlled light turns off.
3. Set the mode selection switch to the RUN position.
•
When the mode selection switch is set to OFF , the large button will
not have any function and the load is disconnected from the power
source. This
must be used when changing light bulbs to ensure that
42
•
Prodigy Media System: PMC2 System User Guide – DOC. 6840A