Crestron MMK-V12, Руководство по установке

Страница: 12 / 20

Mud Mount Kits Crestron MMK-V12 & WMKM-V12
5. When the mud ring plate is in position, bend the top two flanges of the plate
upward and the bottom two flanges downward.
•
If mounting into the PMK-V12, bend the flanges approximately
90 degrees.
•
If mounting into the BB-V12, bend the flanges back as far as they can
go.
6. Use four standard drywall screws (length should not exceed drywall
thickness by more than 1/2” (13 mm)) to secure the mud ring plate to the
rest of the assembly. The screws pass through the clearance holes in the
PMK-V12 (or BB-V12) and are secured in the extruded holes of the
adjustment plates.
7. Verify that the mud ring plate is level.
NOTE: Do not overtighten screws. Doing so can rip the mud ring plate.
8. Use a #2 Phillips screwdriver and tighten the drywall screws by hand so that
they slightly dimple into the holes in the mud ring plate.
9. Apply drywall joint compound as needed to finish the cutout. Avoid
covering the six tapped mounting holes.
10. Run the necessary cables for the touchpanel and secure them behind the
drywall.
11. When dry, the touchpanel can be installed using the six tapped holes in the
PMK-V12 (or BB-V12). Refer to the latest version of the V12-WALL and
WMKC-V12 Installation Guide (Doc. 6893) for installation instructions.
Refer also to the comprehensive illustration shown on page 9.
8
•
Mud Mount Kits: MMK-V12 & WMKM-V12 Installation Guide – DOC. 6892A