Wall Mount
Touchpanels
Crestron Isys
®
TPS-12L/15L/17L
“Ethernet Address” Window
3. Enter a new IP address, IP Mask, Default Router, or select
Enable DHCP
and click
OK
.
NOTE:
The touchpanel is capable of communicating via DHCP (Dynamic Host
Configuration Protocol). A network server uses this protocol to dynamically assign
IP addresses to networked devices. T
he DHCP client is not guaranteed to have a
particular TCP/IP address at any given time. If the DHCP is disabled, the network
administrator must assign the IP address. The Interface menu provides an
enable/disable feature for Ethernet and CIP (Crestron Internet Protocol).
4. Ensure that all devices are connected to the control processor. For TCP/IP,
use CAT5 straight through cables with 8-pin RJ-45 connectors to connect
the LAN port on the touchpanel and the LAN port on the PC to the Ethernet
hub. Alternatively, you can use a CAT5 crossover cable to connect the two
LAN ports directly, without using a hub. The following figure illustrates
pinouts for straight through and crossover RJ-45 cables. Pins 4, 5, 7, and 8
are not used.
RJ-45 Straight Through Cable – For Connection Through Hub
FROM
PIN
COLOR SIGNAL
TO
PIN
SIGNAL
1 White/Orange Tx+
1
Tx+
2
Orange
Tx-
2
Tx-
3 White/Green Rc+
3
Rc+
6
Green
Rc-
6
Rc-
RJ-45 Crossover Cable – For Direct PC Connection
FROM
PIN
COLOR SIGNAL
TO
PIN
SIGNAL
1 White/Orange Rc+
3
Tx+
2
Orange
Rc-
6
Tx-
3 White/Green Tx+
1
Rc+
6
Green
Tx-
2
Rc-
¥
Wall Mount Touchpanels: TPS-12L/15L/17L
Operations Guide – DOC. 6355
52
Содержание Isys TPS-12L
Страница 1: ...Crestron Isys TPS 12L 15L 17L Wall Mount Touchpanels Operations Guide...
Страница 4: ......