Crestron iMedia IM-RXV1, Руководство по эксплуатации и установке

Страница: 15 / 28

Crestron IM-RXV1 & IM-RXV3 iMedia Receiver/Processor with Video
Setup
Network Wiring
When wiring an iMedia system, consider the following:
•
Use Crestron Certified Wire.
•
Use Crestron power supplies for Crestron equipment.
IM Wiring
Using a proprietary signal routing solution, RGBHV, composite video, audio, power
and control signals are all transported using a single cable solution called iMedia.
The iMedia transport system port is capable of managing computer RGB, composite
video, and audio signals simultaneously through one CresCAT-IM cable, simplifying
installations.
Routing CresCAT-IM cable (low-skew CAT5e) is less expensive and a much
simpler solution for the wiring of iMedia systems than routing multi-colored, multi-
conductor coax cable. All Crestron products using the iMedia transport system are
capable of sending and receiving iMedia signals via CresCAT-IM cable. Installation
of any iMedia device is as simple as installing one iMedia cable from output to
input. Installations are affordable, and fast.
Quantity and Packaging
•
CRESCAT-IM-P-B500 is a low-skew CAT5e cable, plenum-rated, available in
a 500 foot box
•
CRESCAT-IM-P-SP500is a low-skew CAT5e cable, plenum-rated, available in
a 500 foot spool
•
CRESCAT-IM-P-SP1000 is a low-skew CAT5e cable, plenum-rated, available
is a 1000 foot spool
For more information on CresCAT and other wire products, visit the Crestron
website (www.crestron.com/features/wire).
Pin Assignments
The pin assignment is based on the EIA/TIA 568B RJ-45 Jack standard.
Power is supplied to the IM transmitters via the audio circuit.
To determine which pin is number 1, hold the cable so that the end of the eight pin
modular jack is facing you, with clip down and copper side up. When looking down
at the copper connections, pin 1 is on the far right.
Operations & Installation Guide – DOC. 6478 iMedia Receiver/Processor with Video: IM-RXV1 & IM-RXV3
•
11