Crestron CNXRMC, Руководство по эксплуатации

Страница: 16 / 36

Room Solution Box Crestron CNXRMC
12
•
Room Solution Box: CNXRMC Operations Guide - DOC. 8162A
"Transmitter Identification" Window
5. Point the universal remote at the CNXRMIRD and program the remote
with an RC5 code (some Sharp codes are acceptable as well) as
outlined in the manufacturer's manual.
NOTE: Crestron recommends that codes from manufacturers other than the
manufacturer of the device being controlled be used to avoid IR transmission
conflict. For example, if the controlled device is a Sony DVD player, an acceptable
code from any manufacturer (except Sony) should be used to communicate with the
Sony DVD player via the CNXRMC.
6. Select one or more function buttons on the remote and observe the
"Transmitter Identification" window on the PC.
a) If there is no activity while pressing buttons on the remote, the
code chosen was not an acceptable code. Repeat steps 5 and 6 with
another code.
b) If activity is observed with each button press, the code used was an
acceptable code and the CNXRMC can accept commands from the
universal remote.
Map the Universal Remote
Once communication between the CNXRMC and the universal remote is achieved, it
is necessary to understand what commands are transmitted and to which devices.
Crestron distinguishes each device with a unique hexadecimal number known as the
Transmitter ID that can range from 00 to 3F. Actually, RC5 codes display these IDs
in the range of 00 to 1F and Sharp codes of suitable format display Transmitter ID
codes in the range of 20 to 3F. Transmitter ID codes are revealed in the "Transmitter
Identification" window.
Each universal remote has a number of source selection buttons on it (i.e., TV, VCR,
DVD, AUX). Typically, those buttons are used when setting up the remote with an
acceptable code (refer to "Code Verification" on page 11). If an acceptable code is
transmitted during that procedure, Crestron assigns the code with an identifier in the
"Transmitter Identification" window. For example, in the window shown on the next
page, the
Transmitter ID (Hex): field shows the number 13. Since the identifier falls
in the range of 00 to 1F, the device communicates using an acceptable RC5 code.