Crestron CLW-SW1, Руководство по эксплуатации

Страница: 13 / 44

Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF infiNET™ Switches
mode. The device is acquired when the LED stops blinking and lights at the
LOW setting. After being acquired, the device will exit the
Acquire mode.
The switch will be acquired on the C2N-MNETGW with an MNET ID
value of 01.
3. Take the C2N-MNETGW out of the Acquire mode once all devices have
been acquired. Refer to the latest revision of the C2N-MNETGW
Operations Guide (Doc. 6137), which is available from the Crestron
website.
To communicate with the control system program, an MNET ID value
between 03 and 20 must be assigned to the switch. For information on
assigning MNET ID values, refer to “Identity Code” on page 12.
Removing Gateway Information from a Switch
In some rare cases, it might be desirable to release a switch from a gateway. If a
switch is to be released from a gateway, the gateway information must be cleared
from the switch’s memory.
To clear a switch’s gateway information:
1. Move the mode selection switch (located under the LED) to the “OFF”
position.
2. Press and hold the top or bottom of the button on the -SW1RF/-SWS1RF or
any button on the -SW4RF/-SWS4RF.
3. While holding the button, slide the mode selection switch to the “RUN”
position.
4. Hold the button for approximately ten seconds until the LED flashes twice.
Immediately release the button after the LED flashes twice to clear the
switch’s gateway information. Reacquire the switch if desired.
A switch can also be released from a gateway using Toolbox. Refer to the latest
revision of the C2N-MNETGW Operations Guide (Doc. 6137) for instructions.
Operation
During operation, the device may be warm to the touch during operation. This is
normal.
Mode Selection Switch
These switches use a three-position mode selection switch to set the mode of
operation.
OFF
When the mode selection switch is in the “OFF” position, the pushbutton(s) will not
have any function and the load is disconnected from the power source. This
must be
used when changing light bulbs to ensure that the load is fully disconnected from
power. Slave devices that are connected to the switch will not have any function
when the Master’s mode selection switch is in the “OFF” position.
Operations Guide - DOC. 6397 infiNET Switches: Crestron CLW-SW1/4RF, -SWS1/4RF, -SLVS1RF
•
9