Ethernet RS-232/422 COM Module
Crestron
CEN-COM
RTS (COM A / B)
If RTS/CTS handshaking is enabled, these LEDs illuminate when the CEN-COM is
ready to receive data from a serial device attached to the respective COM ports.
CTS (COM A / B)
These LEDs illuminate when the serial device on the respective COM port is ready
to accept data from the CEN-COM. This “Clear to Send” signal is available only if
RTS/CTS handshaking is enabled; signal is controlled by external serial device. If
CTS signal is not connected (in cable), the signal is held high and the LEDs are
extinguished.
Leading Specifications
The table below provides a summary of leading specifications for the CEN-COM
module. Dimensions and weight are rounded to the nearest thousandth unit.
Leading Specifications of the CEN-COM
SPECIFICATION
DETAILS
Power Requirements
12 or 24 VDC, Load Factor of 2.5 Watts
SIMPL™ Windows®
Version 1.30.01 or later
1
with the addition of
smwlib45.exe and smwlib45.txt
CNX Upgrade File
Version 5.04.11 or later
2
Crestron Database
Version 11.7.210 or later
1
CEN-COM Upgrade File
Version 1.23 or later
1
Dimensions & Weight
Height: 1.70 in (4.32 cm)
Width: 6.94 in (17.63 cm)
Depth: 6.32 in (16.06 cm)
Weight: 1.90 lb (0.86 kg)
1
The latest software versions can be obtained from the Software Downloads page (SIMPLWIN,
CRESDB, and UPGRADES Libraries) of Crestron’s website (
www.crestron.com)
. New users are
required to register in order to obtain access to the FTP site.
2
Filenames for CNX upgrades have a .upz extension and can be obtained from the Software Downloads
page (OPSYS Library) of the Crestron website.
As of the date of manufacture, the unit has been tested and found to comply with
specifications for CE marking.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) these devices may not cause harmful interference,
and (2) these devices must accept any interference received, including interference
that may cause undesired operation.
Setup
Hardware Hookup
Refer to the hookup diagram after this paragraph. Other than making the power
connection last, complete the connections in any order. The only connection not
6
•
Ethernet RS-232/422 COM Module: CEN-COM
Operations Guide - DOC. 5719
