Crestron
C2N-FT-TPS4/TPS4-U
FlipTop Touchpanel Control Center
Controls and Ports (Top)
Buttons
The TPS-4 touchpanel has 10 hard buttons; five on each side of the display. The
buttons are backlit with white LEDs; brightness is program adjustable. The
buttons can be programmed to automate frequently used functions.
125V – 50/60Hz 10A
AC Outlet (C2N-FT-TPS4 Only)
The 3-prong grounded AC outlet is rated 125 VAC @ 10 Amps, 50 – 60 Hz.
Ports (Underside)
NET
24 Y Z G
24 Y Z G
NET
These two 4-pin terminal block connectors are for connection to the Cresnet
network. One connector is used to connect to the Cresnet network while the
second connector can be used to connect another Cresnet device. Cresnet
power to the TPS4 is supplied through either of these connectors. For more
information, refer to “Network Wiring” on page 8.
LAN
8
1
Yellow
LED
Green
LED
An 8-wire RJ-45 connector with two LED indicators (green LED indicates link
status, yellow LED indicates Ethernet activity). This connector provides an
Ethernet 10baseT /100baseTX, full duplex, TCP/IP, UDP/IP, CIP, DHCP, IEEE
802.3U compliant network connection for the TPS4 touchpanel.
LAN Connector Pinout
PIN
SIGNALS
PIN
SIGNALS
1 TX
+
5 N/C
2
TX -
6
RC -
3 RC+
7 N/C
4
N/C
8
N/C
AC Power (C2N-FT-TPS4 Only)
Connect the six-foot (183 cm) grounded AC line cord to supply AC power to the
outlet on the topside of the TPS4.
Industry Compliance
As of the date of manufacture, the TPS4 has been tested and found to comply with
specifications for CE marking and standards per EMC and Radiocommunications
Compliance Labelling.
NOTE:
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Operations & Installation Guide – DOC. 6398
FlipTop Touchpanel Control center: C2N-FT-TPS4/TPS4-U
•
7