Crestron C2N-CAMIDSPT, Руководство по эксплуатации

Страница: 11 / 40

Crestron C2N-CAMIDSPT Camera Interface, Digital Servo Pan Tilt Head
Operations Guide - DOC. 6262A Camera Interface, Digital Servo Pan Tilt Head: C2N-CAMIDSPT
•
7
Mounting Plates
Adjustable mounting plates and mounting hardware are provided with each
CAMIDSPT. The two plates are to be assembled and mounted to the tilt hub to
provide camera/lens support. The pan hub serves as the mounting platform for the
CAMIDSPT itself.
CAMIDSPT Ports
All connections to the CAMIDSPT are made through the ports on the side panel.
Refer to the illustrations and descriptions, which follow.
CRESTRON
C2N-CAMIDSPT
RS-232
LENS
– NET –
24 Y Z G
PWR
NET SETUP
NET
This 4-pin terminal block connector is used for connection to the control system.
LENS
This DB15 female connector provides three channels for zoom, focus, and iris, as
well as additional signals, depending on the lens. Refer to the diagram and pinout
table below. To properly wire the mating connector, a wiring schematic for each lens
type (A through D) follows the pinout table. Crestron maintains a limited number of
cabling drawings for lenses.
Pin 1
Pin 6
Pin 11
LENS
Connector
CAMIDSPT Pinout for LENS Port
PIN DESCRIPTION PIN DESCRIPTION
1 No connection 9 Iris speed/position select
2 Signal ground – Zoom/Focus
motor 10 Servo 7.5V
3 Zoom drive 11 Servo 2.5V
4 Focus drive 12 Pot 3.3V
5 Iris drive 13 Pot ground
6 Zoom speed/position select 14 Zoom wiper
7 Focus speed/position select 15 Focus wiper
8 Iris local/auto select
NOTE: Most CCTV lenses have an auto iris function and do not have remote iris
control capability.