3
Assembling your
Cresco 10
You will need a phillips head
screwdriver, one pair of plyers/
grips and an m6 metric spanner.
If you are using the spreader
for fertiliser or seed, slide
the summer application into
position as shown above.
ASSEMBLING THE SLIDER SYSTEM, LINKAGE & LOWER FRAME:
Locate the lower linkage (21)
and place it through the pivot
bracket (20).
Push the free end of the lower
linkage (21) through the centre
hole of the chosen slider.
Secure the lower linkage (21) in
place using the R pin small as
shown.
Take the two lower frames (14)
and attach them to the hopper
body (16) using the M6x60 bolts
(9).
SEE NOTE.
When placing the legs on the
hopper, make sure the two
holes on the side of the lower
frame (Item 14) are on the
outside. There should be one
hole on the inside.
2
4
6
7
5
NOTE
Summer Slider
If you are using the spreader
for winter, slide the winter
application into position as
shown above.
1
Winter Slider
Locate & tighten the 4 screws &
washers to fix the required slider
(winter or summer) into position.
Make sure the screws are not
overly tight and the slider can
slide backward and forward.
3
