background image

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

for Cres Cor Refrigerated Cabinets,

Model R-171-S Series

Series R-171-S

Refrigerated Cabinets

FL-2314

Rev. 3 (10/06)

Page 2 of 4

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

Unplug cord from wall. 

1. 

Do NOT hose cabinet with water.

2. 

Do NOT get water into bottom compartment.

3. 

Do NOT use abrasives or harsh chemicals. 

4. 

 Wipe up spills as soon as possible.

 Clean regularly to avoid heavy dirt build-up.

Cleaning Hints:

Use the mildest cleaning procedure that will do the 

1. 

job. 

Always run in the direction of polish lines to avoid 

2. 

scratching the surface. 

Use only a soft cloth, sponge, 

fi

 brous brushes, 

3. 

plastic or stainless steel pads for cleaning and 

scouring. 

Rinse thoroughly with fresh water after every 

4. 

cleaning operation.

Always wipe dry to avoid water marks. 

5. 

HOW TO CLEAN THE CABINET: 

BEFORE cleaning
the cabinet: 

Soil

Cleaner

Method

CABINET

Inside

and

Outside 

(Stainless Steel)

ROUTINE CLEANING

Soap, Ammonia, or mild 
*detergent and water.

1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.

STUBBORN SPOTS 
AND STAINS

Mild abrasive made for 
stainless steel.

1. Apply with damp sponge or cloth. 
2. Rub lightly.

GREASE, OIL

Chemical oven cleaner for 
stainless steel.

Follow oven cleaner manufacturer’s 
directions.

HARD WATER 
SPOTS & SCALE

Vinegar

1. Swab or wipe with cloth.
2. Rinse and dry.

*Mild detergents include soaps and non-abrasive cleaners.

HOW TO REVERSE DOOR HARDWARE FOR OPPOSITE HAND:

(Single Door Cabinet ONLY)

Remove hinge covers with a screwdriver.

1. 

Open door and lift up to remove door from cabinet. 

2. 

Unscrew and re-mount the hinges and latch strike to the opposite 

3. 

sides of the cabinet.
Remove the door hinges and the door latch. Turn hinges and handle 

4. 

over and remount in the same holes
Remove plastic cam from each hinge, rotate cam 180° with “V” 

5. 

groove on cam toward inside of cabinet. Reseat cam into hinge.
Plug all the extra holes with screws.

6. 

Put door onto cabinet and adjust as necessary.

7. 

Snap on hinge covers..

8. 

WARNING

Содержание R171S1828

Страница 1: ... or ending with S Z and or CAN CONTROL PANEL HOW TO INSTALL THE CABINET Remove all packing material from inside the 1 cabinet INSTALL ALL ANGLES 2 BEFORE UNIT IS TURNED ON Allow enough clearance around cabinet for air 3 flow HOW TO OPERATE Plug cord into proper wall outlet 1 Turn the power switch to ON Light will come 2 on and compressor will start Listen closely for the compressor It will be slig...

Страница 2: ...t Soil Cleaner Method CABINET Inside and Outside Stainless Steel ROUTINE CLEANING Soap Ammonia or mild detergent and water 1 Sponge on with cloth 2 Rinse with water 3 Wipe dry STUBBORN SPOTS AND STAINS Mild abrasive made for stainless steel 1 Apply with damp sponge or cloth 2 Rub lightly GREASE OIL Chemical oven cleaner for stainless steel Follow oven cleaner manufacturer s directions HARD WATER S...

Страница 3: ...ly Failure Probable Cause 1 Power light off 1 Power Cord 2 Compressor off 2 Power supply down 3 Evaporator fan on Power light on and Compressor off 3a Thermostat defective 3b Defective start relay compressor 4 Compressor on and cabinet not cooling 4a Low charge 4b Frost build up on evaporator coil 4c Evaporator fan defective 4d Thermostat defective 5 Compressor starts and stops cabinet not cooling...

Страница 4: ...1221 553 K 1221 553 K Evaporator Assembly for R171SUA10 1828 1416 068 K 1416 070 K Evaporator Assembly for R171SUA20 1856 1416 069 K 1416 071 K Gasket Kit 0861 261 0861 261 Hinge Kit 0519 087 K 0519 087 K Pilot Light Power ON 0766 094 0766 095 Post 0696 237 0696 237 Receptacle 0713 057 0713 058 Switch ON OFF 0808 116 0808 116 Terminal Block 0852 091 0852 091 Thermometer Kit 5238 035 K 5238 035 K T...

Отзывы: