5925 Heisley Road • Mentor, OH 44060-1833
Series R-171-E
Refrigerated Cabinets
FL-2400
Rev. 2 (5/19)
Page 5 of 9
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
9 . To unlock:
a. Press and hold the ↑ and ↓ buttons together for
more than 3 seconds
b .“Pon” will be displayed .
10 . It is not recommended to ever put any hot, warm,
or room temperature product into the refrigerator .
If something needs to be cooled down at a faster
rate than normal (e .g . a large load of cool product
is placed into the refrigerator and needs to become
cold), press and hold the ↑ button for 3 seconds
and the refrigerator will run to below the normal
setpoint for about 40 minutes to aid in pulldown .
a. Yellow snowflake will illuminate.
b .NOTE: this process will not initiate if the
cabinet is in a defrost cycle .
TO SHUT UNIT OFF:
1 . Press power switch “OFF”
HOW TO REVERSE DOOR SWING FOR
OPPOSITE HAND:
(Single Door Cabinet ONLY)
1 . Remove hinge covers with a screwdriver .
2 . Open door and lift up to remove door from
cabinet .
3 . Unscrew and re-mount the hinges and latch strike
to the opposite sides of the cabinet .
4 . Remove the door hinges and the door latch . Turn
hinges and handle over and remount in the same
holes
5 . Remove plastic cam from each hinge, rotate cam
180° with “V” groove on cam toward inside of
cabinet . Reseat cam into hinge .
6 .
Plug all the extra holes with screws.
7 . Put door onto cabinet and adjust as necessary .
8 . Snap on hinge covers . .
1.
Unplug cord from wall.
2.
Do NOT hose cabinet with water.
3.
Do NOT get water into bottom compartment.
4.
Do NOT use abrasives or harsh chemicals.
■ Wipe up spills as soon as possible.
■ Clean regularly to avoid heavy dirt build-up.
HOW TO CLEAN THE CABINET:
BEFORE
cleaning
the cabinet:
WARNING
Cleaning Hints:
1 . Use the mildest cleaning procedure that will do the
job .
2 . Always run in the direction of polish lines to avoid
scratching the surface .
3 .
Use only a soft cloth, sponge, fibrous brushes,
plastic or stainless steel pads for cleaning and
scouring .
4 . Rinse thoroughly with fresh water after every
cleaning operation .
5 . Always wipe dry to avoid water marks .
OPERATING INSTRUCTIONS
(continued)
