Page: 2
Insert the
Flat Foil Cable
(FFC), exiting from the AMBIT module, into the appropriate
socket on the Pre-amp PCB below it, marked
MODULE
. The AMBIT PCB should now be
held upside-down (components facing down, bare PCB facing upwards) with the antenna
sockets facing backwards towards the rear panel. Fold the loose FFC under the AMBIT
PCB.
1.
For EVOLUTION 50A version 1: Push the antenna sockets through the appropriate
holes on the rear panel. Using the retained screw, fix the AMBIT module firmly onto
the rear panel, using the Torx T7 screw driver supplied in the pack.
2.
For EVOLUTION 50A version 2: Line the plate up with the expansion slot in the
rear panel. Using the screws previously removed, fix the AMBIT module firmly onto
the rear panel, using the Torx T7 screw driver, supplied in the pack.
Replace the cover as before, making sure to put the cutting washer back on the same
screw position.
FU
S
E
:
T5
A
L2
50
V
U
S
E
R
AT
E
D
F
U
S
E
O
N
LY
CONNECTING ANTENNA
To get you started quickly, Creek Audio has included a 1.5 metre length of wire with a
co-ax plug at one end, to act as a temporary
FM
antenna. Adjust the position of this tem-
porary antenna for best results. However, to obtain the best
FM
signal, use a high quality,
multi-element, directional external VHF -
FM
antenna. If in doubt consult your supplying
Hi-Fi dealer, or a specialist antenna installation company for advice.
An
AM
loop antenna is also supplied for indoor use only. Connect the two-wire loop anten-
