Credo 4499 Series, Руководство по установке

Страница: 6 / 16

6
AU Freephone 1300 538 598
E sales@trailparts.com.au
www.trailparts.com.au
Credo Hydraulic Installation Instructions
The earth from the BrakeRite actuator and the trailer battery must only connect to the brake
controller output earths as shown in the diagram. They cannot be connected to a common
chassis earth.
Cable gauge should be of sufficient size to avoid voltage drop. The main power feeds to the
actuator from the brake controller should be minimum 20amp.
Mount the actuator in a protected position. Orientation is not important for this, but filler caps
should be level and upright.
Do not run the actuator without fluid as this will damage the pump.
Use new DOT 3 or DOT 4 brake fluid.
Bleed the brakes by activating the breakaway switch. However, do not run the actuator
continuously for more than 1 minute every 5 minutes. All air must be removed from the system
for the brakes to work correctly. Ensure that the fluid level does not drop below 20mm from the
filler cap opening to avoid more air being pumped into the system.
Credo General Installation Instructions
Credo Hydraulic Instructions
(Applies to Serial # 900-4499)
Mount the brake controller according to the mounting orientation instructions on page 11.
Wire the brake controller according to the instructions on page 11.
It is important that trailers fitted with the Credo™ braking system are also fitted with 12/24 volt
LED lights, not voltage specific incandescent or LED lights.
Maximum of 2 tail lights and 4 marker lights to be connected to the unit. If more are required
please phone us for installation support.
Controller must be mounted to a metal surface which is mounted to the main chassis.