12
HOW TO USE YOUR
SPA100
SHOWER (SUMMARY)
IMPORTANT WARNINGS!
DO NOT SWITCH THE APPLIANCE ON IF YOU SUSPECT IT OF BEING FROZEN.
WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT.
DO NOT OPERATE THE APPLIANCE IF WATER DISCHARGES FROM THE PRESSURE RELIEF
VALVE. MAINTENANCE IS REQUIRED BEFORE THE APPLIANCE CAN BE SAFELY USED.
THIS APPLIANCE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN AND
THE INFIRM) WITH REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES,
OR LACK OF EXPERIENCE AND KNOWLEDGE, UNLESS THEY HAVE BEEN GIVEN SUPERVISION
OR INSTRUCTION CONCERNING USE OF THE APPLIANCE
BY A PERSON RESPONSIBLE FOR THEIR SAFETY.
CHILDREN SHOULD BE SUPERVISED TO ENSURE THAT THEY
DO NOT PLAY WITH THE APPLIANCE.
1.
Ensure the electricity and water are turned on to the unit.
2.
Turn outer knob “A” clockwise
to the
“Power Select”
position of your choice.
= High Power
= Medium Power
= Cold Shower
The water will flow, and the neon indicator light will glow.
It is recommended that you do not enter the water spray
during this period, even if the shower has just been used.
3.
Turn inner knob “B” a small amount
until you reach
the desired showering
temperature
.
Turn anti-clockwise (follow blue arrows) for cooler.
Turn clockwise (follow red arrows) for warmer.
4.
When you have finished showering,
turn outer knob “A” anti-clockwise
to the “ ” position.
(You have no need to adjust inner knob “B”).
5.
Water will continue to flow for up to 3 seconds before switching off.
This reduces the temperature of the water in the tank for the next user.
The neon indicator light will go out.
6.
Switch off the electricity supply at the ceiling switch or local isolator.
Notes
•
Wait 20 seconds for the temperature to stabilise after each adjustment.
•
The neon indicates when the heaters are on and, if the shower has been recently used, it
may take up to 20 seconds to come on.
During this time the water may go from very hot to cold before stabilising.
Also, please note that the neon indicator does not light when the shower is set to the
“
“ cold power setting.
•
The position of inner knob “B” will be approximately the same each time the shower is
used, varying only with incoming water temperature or pressure changes
(e.g. you will only need to change from summer to winter).
•
During normal operation, if an overheated water temperature is sensed then the heater
will switch off and the neon indicator will go out.
Water will continue to flow and cool down before the heater switches back on again.
We offer a technical advisory service on the telephone: RING 0844 372 7766 (UK ONLY)
(A4) Leaflet No. 555-2136-61b
IMPORTANT:
This booklet should be left with the user after
installation and demonstration
CREDA SPA100
SMART TECHNOLOGY
ELECTRIC SHOWER
Installation and User Guide