Creda Eco-Response ER300, Руководство по установке

Страница: 5 / 12

- 5 -
6
Stand the radiator on its feet and against a wall.
Remove the securing screws along the bottom edge
of the front panel.
7
Swing bottom of panel slightly away from the rest of
the radiator (Fig. 7
A
) and lift upwards to unhook the
top edge (Fig. 7
B
).
6
7
A
7
B
5
Stand the radiator on its feet and remove packaging
by sliding over the top of the radiator. Remove all
additional internal protective packaging.
5
8
Ensure the electronic components are not damaged
when removing the panel. Carefully place the panel
to one side. Check that the mains supply cables are not
damaged.
If they are to be replaced only heat resistant cable must be
used (min T85). Refer to sections 4, 21 and 22 for fitting the
off-peak and radiant element cables.
9
Position radiator against wall in intended final position,
ensuring it is on a firm base and taking note of the
minimum fixing dimensions (see front page).
If the floor is carpeted it is important that the feet are
positioned firmly and securely. The feet may rest on
top of the carpet, however carpet gripper should be removed
around the feet so that the radiator rests in a level position.
10
7
D
Carefully disconnect the
radiant element connector
from the front panel (Fig. 7c).
(See label on bottom of heater
and graphic 7
D
below).
7
C