IMPORTANT -
Remember to observe all safety warnings and precautions when operating the heater
on the automatic or timer modes, either attended or unattended.
Note that due care and consideration must be taken when using this heater in series with the built-in
thermal control, program controller, timer or any other device that switches on the heat automatically,
since a fire risk exists when the heater is accidentally covered or displaced.
CAUTION -
Do not use if the heater’s mains power lead is damaged.
WARNING - This heater must be earthed
The electrical installation must be carried out by a suitable qualified or trained electrician, and
be in strict accordance with the current wiring Regulations BS7671 for Electrical Equipment
in Buildings. The wires in this mains lead are coloured in accordance with the following code:
GREEN AND YELLOW:
EARTH
BLUE:
NEUTRAL
BROWN:
LIVE
The heater is fitted with a length of flexible cable type H05VV-F size 3 x 1.0mm
2
for connection to the
fixed wiring of the premises through a suitable double pole switched fused spur, with the fuse rated
correctly for the appliance, positioned adjacent to the heater. A means for disconnection must be
incorporated in the fixed wiring of the premises in accordance with the wiring regulations.
Please note that lit cigarettes, candles and oil burners, combined with the convection effect of electric
heaters can cause significant soot deposits to build up on the surface directly above and to the sides
of the heater. This is not a fault of the heater. Extensive burning of candles or smoking in the operating
environment of this product can produce heavy discolouration within a few months of use.
WARNING - This heater must not be connected to the electricity supply via an external switching
device (such as a timer) or a circuit that is regularly switched on and off by the utility supplier. Failure
to follow this warning could result in the heater’s thermal cut-off being inadvertently re-set and could
create a fire hazard.
This heater is filled with a precise quantity of special oil. Repairs requiring opening of the oil container
are only to be made by the manufacturer or the manufacturer’s service agent who should be contacted
if there is an oil leakage. Regulations concerning the disposal of oil when scrapping the heater have to
be followed.
If the supply cord is damaged it must be replaced by the manufacturer or approved service partner
SAFETY - Overheat protection
For your safety this heater is fitted with a thermal cut-out. In the event that the product overheats for
some reason, the cut-out prevents excessive temperatures on the product by cutting the power to the
heater. Once the heater has cooled down, it will reset automatically, it will continue to cycle on and off
automatically until the reason for overheating is removed. The display screen may flash red to indicate
the product has overheated. To reset the display, remove the obstruction and hold Enter for 10 seconds.
WARNING -
Servicing and product repairs should only be undertaken by the manufacturers approved
service agent or a similarly trained or qualified person, using only exact manufacturer approved spare
parts.
3