Creative Four Point Surround FPS1000, Руководство пользователя

Страница: 10 / 18

10
Attaching The Desktop Stands
For most applications, the satellite
speakers should be used with their
desktop stands. Install each stand by
inserting it into the “T” shaped
socket in the back of each satellite.
Make sure to feed the wires through
the cut-out in the top of the desktop
stands (see diagram C).
For desktop placement, apply the
five self adhesive feet to the base of
the desktop stands. If you wish to
install the rear satellites in the floor
stands, do not apply the self
adhesive feet to the base of their
desktop stands (see diagram D).
D
C
Attaching The Floor Stands
apex joint.
4. Slide the back of the satellite’s
desktop stand into the front of
the slot in the apex joint. The
slot’s front is the side further
away from the rear leg socket.
Make sure the stand is securely
pressed into the slot (see
Diagram F).
5. At the base of the rear leg,
gently pull on the satellite cable
to remove any unnecessary
slack in the cable.
6. Insert a rubber plug into the
base of each leg, taking care to
feed the cable out the short
notch in the rear leg (see
Diagram G).
The rear satellites (with their
desktop stands attached) may be
installed in their floor stands.
1. One leg of each floor stand has
a full length slot, with short
notches opposite the slot at
each end. Insert a satellite cable
inside one of these legs by
feeding it down the length of
the full length slot. At each end,
feed the cable through the short
notches (see Diagram E).
2. Ensure there are no feet
attached to the satellite’s
desktop stand. Insert the
satellite end of the leg/cable
assembly into the middle socket
of the apex joint. Make sure the
satellite cable exits through the
short notch and not the full
length slot (see Diagram F).
3. Insert the two solid legs into
the outside sockets in the
E