© Copyright 2016, Creative Playthings
NORFOLK II
19944-200 Rev E (01-19)
Page 18
ASSEMBLY INSTRUCTIONS
STEP 31 – Hand Grips (part one):
Place one Hand Grip (CC) flat against the outside face of the
right back Post as shown. The bottom hole of the Hand Grip
should be approximately 3-3/4" above the top of the Leg.
With the Hand Grip centered on the face of the Post, mark
the positions of the holes in the Hand Grip. Drill 1/8" diameter
pilot holes 1" deep at the marks. Fasten the Hand Grip using
two 1/4" x 1-1/2" Lag Screws and two 8mm Flat Washers.
Place one Hand Grip flat against the angled face of the front
right Leg as shown. The top hole of the Hand Grip should be
approximately 7-3/4" below the top of the Leg.
Mark the positions of the holes in the Grip. Drill and fasten the
Hand Grip as above.
STEP 29 – Swing Mount (Optional):
If you do not plan to install a 7 foot Swing Beam, do not
install the Swing Mount.
Find the center of the Main Beam and Wall Support on the
back of the tower. (The Bolts securing the Center Block are
at the center of the Main Beam). Mark the Main Beam and
Wall Support 2" from center. Hold the Swing Mount (MM)
against the back of the Gym with one edge against the marks
and align the top of the Swing Mount with the top of the Wall
Support. Use a level to make sure the Swing Mount is plumb.
Mark the position of the holes in the Swing Mount on the
Beam and Support. Drill 3/8" diameter holes through the
boards at the marks
Fasten the Swing Mount to the Main Beam and Wall Support
using two 5/16 x 4" Hex Bolt Assemblies as shown at right.
Install the Swing Beam as instructed by the assembly guide
included with the Beam.
Wall
Support
Main
Beam
Back of Gym
2"
MM
CC
M
STEP 30 — Wall Slats:
Evenly space six Wall Slats (M) between the back Posts.
Fasten each Wall Slat to the back Wall Support and the back
Main Beam using four #8 x 1-5/8" Screws. The gap will be
approximately 3" between slats.
Secure one Wall Slat 27-1/2" from the right front Post
using four #8 x 1-5/8" Screws. Evenly space two Wall Slats
between the front left Post and the Wall Slat. Fasten each
Wall Slat to the front Wall Support and the front Main Beam
using four #8 x 1-5/8" Screws. The gap will be approximately
3" between slats.
WARNING: at no time should the opening between Wall
Slats and any other member be greater than 3-1/2" and less
than 9"; fatal injury could result.
Front of the Gym
3" T
ypical
3" T
ypical
27-1/2"
Roof omitted
for clarity.
Center
Line
3-3/4"
7-3/4"
1/4 x 1-1/2"
Lag Screw
The Swing Mount is
required for a 7 foot
Swing Beam only.
Note: Use a C-Wrench or ratcheting box wrench to tight-
en the Lag Screws; a power tool can scar the Hand Grip.
